DIY Water Heater Repair Recommendations in Atwood

Suppose you are trying to find experienced Water Heater Repair in Atwood. In that case, we have a fantastic team of knowledgeable plumbers who can rapidly detect the source of the problem and get it repaired fast to ensure that you can return to enjoying a hassle-free life, with guaranteed satisfaction from the really first call.

Nonetheless, If you mean to take the threat of carrying out a water heater repair by yourself, these are some standard steps to do so:

Shut off the water system to the water heater, shut down the electrical power, have an electrically powered water heater, or the gas source if you have a gas water heater.

Drain the water from the water heater tank by opening the valve at the bottom of the tank near the floor. It might be valuable to connect a garden hose to the drain valve and run it to a close-by drain to prevent a huge mess.

Once the tank is empty, you can detach the gas line, flue pipe, and water lines for a gas water heater or the power wires and water lines for an electric water heater. The water heater may still be a little heavy, so you may want to use a dolly to remove it from your house.

When it is out of the way, tidy up the location to make it set for the new water heater. Once the site is prepared, you can set the new unit in place and begin reconnection of the water lines, the gas or electric supply, and the flue pipe for the gas water heater. Make certain that you check your gas line joints with soap bubbles for gas punctures when it comes to a gas water heater.

Switch the gas/power on and start filling up the water tank. For the gas water heater, you must absolutely likewise remember to light up the pilot burner. You also want to ensure that the thermostat is set to the temperature that you want, the most common setting is 120 degrees Fahrenheit. At this moment, your new water heater ought to be set to go.

Replacing a Water Heater Valve

Water may likewise leak from the pressure relief valve on the water heater. This could be brought on by either a defective valve or a high-pressure situation in the water heater. If the valve itself is bad, it can be replaced in a number of steps:

Turn off the water heater, shut down the supply of water and drain a few of the water from the tank.

Raise the little lever on the valve to discharge any continuing to be pressure.

Use a wrench to loosen the valve from the tank and change it with a brand-new valve.

Usage Teflon tape on the threads of the new valve before you screw it into the water heater.

You must then be safe to refill and turn the water heater back on. The majority of other leakages you might come across are fixed by tightening loose valves or fittings on the water heater and the connected pipes.

Typical Water Heater Complications in Atwood
Common Water Heater Tank Types in Atwood