DIY Water Heater Repair Recommendations in Valencia

Imagine you are looking for experienced Water Heater Repair in Valencia. In that case, we have a great group of knowledgeable plumbing professionals who can immediately identify the source of the issue and get it fixed quick to make sure that you can return to enjoying a stress-free life, with guaranteed satisfaction from the extremely first call.

Nonetheless, If you aim to take the threat of carrying out a Water Heater Repair in Valencia on your own, these are some standard steps to do so:

Shut off the supply of water to the water heater, turned off the electrical power, have an electric water heater, or the gas supply if you have a gas water heater.

Drain the water from the water heater tank by opening up the valve at the bottom of the tank near the floor. It may be helpful to connect a garden hose pipe to the drain valve and run it to a close-by drain to avoid a huge mess.

Once the tank is empty, you can disconnect the gas line, flue pipe, and water lines for a gas water heater or the power wires and water lines for an electric water heater. The water heater may still be a little heavy, so you may wish to use a dolly to remove it from your house.

When it is out of the way, clean the location to make it all set for the brand-new water heater. When the site is prepared, you can set the brand-new unit in place and start reconnection of the water lines, the gas or electrical supply, and the flue pipe for the gas water heater. Guarantee that you check your gas line joints with soap bubbles for gas punctures when it comes to a gas water heater.

Switch the gas/power on and start refilling the water tank. For the gas water heater, you have to additionally keep in mind to light the pilot light. You also wish to make certain that the thermostat is set to the temperature level that you want, the most common setting is 120 degrees Fahrenheit. At this moment, your brand-new water heater need to be set to go.

Switching Out a Water Heater Valve

Water may also leakage from the pressure relief valve on the water heater. This could be brought on by either a defective valve or a high-pressure circumstance in the water heater. If the valve itself is bad, it can be changed in several steps:

Shut down the water heater, turned off the water supply and drain some of the water from the tank.

Lift the little lever on the valve to release any continuing to be pressure.

Utilize a wrench to loosen the valve from the tank and change it with a new valve.

Use Teflon tape on the threads of the new valve before you screw it into the water heater.

You should then be safe to refill and turn the water heater back on. A lot of other leakages you might encounter are repaired by tightening loose valves or fittings on the water heater and the connected pipes.

Plumbing Service – Water Heater Repair in Valencia
Typical Water Heater Tank Types in Valencia