.
It’s easy to get overzealous and thrill through a Garbage Disposal Installation in Downey, however it’s important to decelerate and take the time to go detailed for a proper garbage disposal installation.
Our qualified plumbers comply with these steps thoroughly, and they can do the task quickly and expertly. Below we give you a checklist of the steps that our expert garbage Disposal installation group follow for a successful project:
.
Shut off the circuit breaker for your kitchen.
.
Get rid of the basket filter and any excess plumber’s putty or caulking that might have been used to seal the filter to the sink bowl where you intend to install the garbage disposal.
.
You will need to acquire a garbage disposal flange kit if your new device didn’t come with one. Apply plumbing’s putty around the flange and press it into place. Set a washcloth in the sink and place the disposal on the flange to maintain it from moving.
.
Under the sink, stack the rubber gasket against the bottom of the sink, then the mounting reinforcement and snap the snap ring into place.
.
Tighten the three bolts on the mounting bracket up until snug.
.
Utilize a hammer to knock out the drainpipe plug from the dish washer drainpipe opening on the disposal. DO NOT knock it out if there isn’t a dishwashing machine in the kitchen.
.
Remove the cable cover plate and attach the electric cord to the power supply. Push the cords back in and reattach the plate.
.
To link the drain, place the gasket in the discharge electrical outlet. Attach the discharge tube with the flange and bolts.
.
Line up the 3 tabs with the installing ring. Make use of a wrench to turn and lock the tabs over the ridges. Link the dishwasher drain. The discharge needs to be lined up correctly; then, you can reconnect your drain pipes. Next, test the disposal.
.
There are some things you can do after garbage disposal installation to make sure your garbage disposal runs efficiently and operates accurately for a long period of time.
.
Keep your garbage disposal clean. Put some dish soap inside and allow it run for around a minute with cold water after use.