When you have a blocked drain in your house, your very first intuition is most likely to get a plunger. Little do you know; there are some cases where basic plunging is nearly ineffective, like when the primary sewer line in your house gets blocked. When this happens, you can end up with widespread flooding and pipes issues all over your house.
1. Loosen the Drain Pipeline Cap (Cleanout Pipeline)
The very first step is to find your primary drain cleanout location. Try to find a little white pipeline that sticks a few inches out of the ground. It is often situated near a flower bed. Use the pipe wrench to loosen up the cap. Do it slowly, and allow it to sit for a few seconds prior to eliminating the cap entirely. This will help you prevent any unexpected sewage or water spillage. Be ready to step away.
2. Eliminate Cap, Enable Accumulation to Drain
As soon as you eliminate the cleanout cap, step away rapidly. The obstruction will probably have caused waste to develop. When you eliminate the cap, it may come spilling out rapidly. Allow the pipe to drain excess water completely prior to you attempt to do anything else. This is where the waterproof boots and gloves will come in convenient!
3. Place the Snake into Pipe
As soon as the pipeline has finished draining, start carefully feeding the drill into the opening. Make sure to read the instructions before you begin; each pipe snake will have somewhat various directions. Augers are common tools utilized by Arlington drain cleaning professionals. If you don’t have one, think about renting from a hardware shop for one-time usage. Feed the drill gradually into the pipe till you reach the clog. You’ll know you’ve hit it when the snake becomes hard to move. There might be more than one but work your method down.
4. Run the Tool Until Obstruction Is Gone
Run the drill until you don’t feel any more resistance, and the water build-up in the pipe is gone. This shows the blocked pipeline is clear. Continue to run the drill even after the obstruction is gone, as there could still be small clumps of particles after the drain clog has cleared or broken up.
5. Clean Up
After you are done, leave the auger in the pipeline and hose pipe it down with water. Ensure the nozzle is on full blast and provide everything a comprehensive rinse– as this will help clear out any remaining scrap that could trigger another obstruction. Afterward, you’ll also wish to hose down the pipeline snake before you put it away.
If, after following those steps, your primary drain line is still blocked, you might require to use a hydro-jetting service that has more power and the ability to reach the obstruction. It might be time to call a licensed plumbing business to help.
Often, other more extreme plumbing problems can provide as a sewer backup. If left unattended, they can result in thousands of dollars of damage down the road. This is much better to avoid with a little cost now for comfort.
If you’re still having problem locating your clog or clearing your drain, give us a call today for Main line cleaning in San Marino service.
How to Recognize a Sewer Main Line Concern in San Marino
Main Line Cleaning with Hydro Jetting in San Marino