What to Think About During Garbage Disposal Installation in Canyon Country

There are a few things to consider during Garbage Disposal Installation in Canyon Country. Before you start, you might want to consider:

1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be taken into consideration an essential part of Garbage Disposal Installation in Canyon Country. However, if you already have a sump pump, you may want to consider installing a 2nd back-up sump pump. If you intend to have a battery-backup sump pump, you will be prepared in case of a power outage.

2. Connection of Water Line- Your primary source of water may be from the house’s utilities. Suppose your utility is the first source of water. In that case, you will want to set up a U-shaped copper or cast iron pipe just about 18″. To fulfill city regulations in most areas, the pipe should be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Guarantee that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.

3. Proper Disposal- Check with your local codes to know what size drain line and fill your appliance will require. If your disposal is a combination of disposal and garbage furnace, you will want to install 2 discharge lines. The cold one need to be hooked up to the outside discharge, and the hotline should be installed on the plenum flange.

4. Steps- The cold line will be connected to the rough-in drainpipe. The hotline will be connected to the top of the disposal, and the cold outlet line along with the drainpipe line will be attached to the drain installation. With a buddy, you will then tape the drain lines to the plenum flange using air duct tape.

5. Connecting the garbage disposal and the disposal water line to the house’s electrical device.

6. Securing the outside of the garbage disposal. This will require protecting the old fast-food outlet. The garbage disposal is connected to the backside of the device with 2 screws. The fast-food outlet will be on the right side.

7. Replacing the flange and cover plate. The plenum flange will have four screws, and the cover plate will have 2 screws.

8. Protecting the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by loosening the nuts. The base will lift free.

Plumbing Service – Repair and replacement – Garbage Disposal Installation in Canyon Country
Garbage Disposal Installation: In Detail in Canyon Country