There are a few things to think about throughout Garbage Disposal Installation in Downey. Before you start, you may want to think about:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be taken into consideration an essential part of garbage disposal installation. However, if you already have a sump pump, you may want to think about installing a second back-up sump pump. If you intend to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water may be from the house’s utilities. Suppose your utility is the first source of water. In that situation, you will want to install a U-shaped copper or cast iron pipe almost 18″. To satisfy city regulations in many areas, the pipe must be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Make sure that you have an appropriate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Appropriate Disposal- Check with your local codes to know what dimension drain line and fill your device will require. If your disposal is a mix of disposal and trash furnace, you will want to install 2 discharge lines. The cold one ought to be hooked up to the outside discharge, and the hotline ought to be installed on the plenum flange.
4. Levels- The cold line will be connected to the rough-in drainpipe. The hotline is going to be connected to the top of the disposal, and the cold outlet line along with the drain line will be attached to the drainpipe fitting. With a buddy, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electrical system.
6. Securing the outside of the garbage disposal. This will require securing the old fast-food outlet. The garbage disposal is attached to the backside of the unit with two screws. The fast-food outlet will be on the right side.
7. Changing the flange and cover plate. The plenum flange will have four screws, and the cover plate will have 2 screws.
8. Securing the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by loosening the nuts. The base will lift free.
New Garbage Disposal Installation Guide in Downey
Installing a New Garbage Disposal in Downey