There are a few things to think about during Garbage Disposal Installation in La Puente. Before you start, you might want to consider:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be considered an essential part of garbage disposal installation. However, if you already have a sump pump, you might want to think about installing a 2nd back-up sump pump. If you plan to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water might be from the home’s utilities. Suppose your utility is the first source of water. In that case, you will want to install a U-shaped copper or cast iron pipe almost 18″. To fulfill city regulations in most areas, the pipe must be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Ensure that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Appropriate Disposal- Check with your local codes to know what size drain line and fill your appliance will require. If your disposal is a combination of disposal and garbage furnace, you will want to install two discharge lines. The cold one should be connected to the external discharge, and the hotline should be installed on the plenum flange.
4. Steps- The cold line will be connected to the rough-in drain. The hotline will be connected to the top of the disposal, and the cold outlet line along with the drain line will be connected to the drain installation. With a friend, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electric unit.
6. Securing the outside of the garbage disposal. This will require securing the old fast-food outlet. The garbage disposal is connected to the backside of the device with two screws. The fast-food outlet will be on the right side.
7. Changing the flange and cover plate. The plenum flange will have four screws, and the cover plate will have 2 screws.
8. Securing the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by unscrewing the nuts. The base will lift free.
Installing a New Garbage Disposal in La Puente
Everything You Required to Know About Garbage Disposals in La Puente