There are a few things to think about throughout Garbage Disposal Installation in Lytle Creek. Before you begin, you may want to consider:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be considered a needed part of Garbage Disposal Installation in Lytle Creek. However, if you already have a sump pump, you might want to consider installing a 2nd back-up sump pump. If you plan to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water might be from the house’s utilities. Suppose your utility is the first source of water. In that situation, you will want to set up a U-shaped copper or cast iron pipe almost 18″. To satisfy city regulations in most areas, the pipe should be a minimum of 18″ maximum in depth when complete. The line will carry the disposer and water to the ground slope. Guarantee that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Appropriate Disposal- Check with your local codes to know what dimension drain line and fill your device will require. If your disposal is a mix of disposal and garbage furnace, you will want to install two discharge lines. The cold one ought to be connected to the external discharge, and the hotline should be installed on the plenum flange.
4. Levels- The cold line will be connected to the rough-in drainpipe. The hotline is going to be connected to the top of the disposal, and the cold outlet line along with the drain line will be attached to the drainpipe fitting. With a buddy, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electrical system.
6. Securing the outside of the garbage disposal. This will require protecting the old fast-food outlet. The garbage disposal is connected to the backside of the unit with 2 screws. The fast-food outlet will be on the right side.
7. Changing the flange and cover plate. The plenum flange will have 4 screws, and the cover plate will have 2 screws.
8. Protecting the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by loosening the nuts. The base will lift free.
Installing a New Garbage Disposal in Lytle Creek
Setting Up a Replacement Garbage Disposal in Lytle Creek