There are a few things to consider during Garbage Disposal Installation in Mission Hills. Before you begin, you might want to think about:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be taken into consideration a necessary part of Garbage Disposal Installation in Mission Hills. However, if you already have a sump pump, you might want to consider installing a second back-up sump pump. If you plan to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water might be from the home’s utilities. Suppose your utility is the first source of water. In that case, you will want to set up a U-shaped copper or cast iron pipe almost 18″. To satisfy city regulations in most areas, the pipe should be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Ensure that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Appropriate Disposal- Check with your local codes to know what dimension drain line and fill your appliance will require. If your disposal is a mix of disposal and garbage furnace, you will want to install two discharge lines. The cold one ought to be hooked up to the external discharge, and the hotline ought to be installed on the plenum flange.
4. Steps- The cold line will be connected to the rough-in drain. The hotline will be connected to the top of the disposal, and the cold outlet line along with the drain line will be attached to the drainpipe fitting. With a friend, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electrical unit.
6. Securing the outside of the garbage disposal. This will require securing the old fast-food outlet. The garbage disposal is connected to the backside of the device with two screws. The fast-food outlet will get on the right side.
7. Replacing the flange and cover plate. The plenum flange will have 4 screws, and the cover plate will have two screws.
8. Securing the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by loosening the nuts. The base will lift free.
Garbage Disposal installation for brand-new homes in Mission Hills
DIY Garbage Disposal Installation in Mission Hills