There are a few things to consider throughout Garbage Disposal Installation in Mission Viejo. Before you begin, you might want to consider:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be taken into consideration an essential part of garbage disposal installation. Nevertheless, if you already have a sump pump, you might want to think about installing a 2nd back-up sump pump. If you plan to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water might be from the house’s utilities. Suppose your utility is the first source of water. In that situation, you will want to install a U-shaped copper or cast iron pipe almost 18″. To satisfy city regulations in most areas, the pipe needs to be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Guarantee that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Suitable Disposal- Check with your local codes to know what size drain line and fill your device will require. If your disposal is a mix of disposal and garbage furnace, you will want to install 2 discharge lines. The cold one need to be hooked up to the outside discharge, and the hotline needs to be installed on the plenum flange.
4. Levels- The cold line will be connected to the rough-in drainpipe. The hotline will be connected to the top of the disposal, and the cold outlet line along with the drainpipe line will be attached to the drain fitting. With a friend, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electrical system.
6. Securing the outside of the garbage disposal. This will require protecting the old fast-food outlet. The garbage disposal is attached to the backside of the unit with 2 screws. The fast-food outlet will be on the right side.
7. Changing the flange and cover plate. The plenum flange will have four screws, and the cover plate will have two screws.
8. Protecting the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by unscrewing the nuts. The base will lift free.
Mounting a Substitute Garbage Disposal in Mission Viejo
How to Install a Garbage Disposal in Mission Viejo