There are a few things to think about during Garbage Disposal Installation in Pacoima. Before you start, you might want to consider:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be taken into consideration a necessary part of Garbage Disposal Installation in Pacoima. However, if you already have a sump pump, you might want to think about installing a second back-up sump pump. If you intend to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water might be from the home’s utilities. Suppose your utility is the first source of water. In that case, you will want to install a U-shaped copper or cast iron pipe almost 18″. To fulfill city regulations in many areas, the pipe should be a minimum of 18″ maximum in depth when complete. The line will carry the disposer and water to the ground slope. Ensure that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Appropriate Disposal- Check with your local codes to know what size drain line and fill your appliance will require. If your disposal is a combination of disposal and trash furnace, you will want to install two discharge lines. The cold one should be hooked up to the external discharge, and the hotline ought to be installed on the plenum flange.
4. Levels- The cold line will be connected to the rough-in drainpipe. The hotline is going to be attached to the top of the disposal, and the cold outlet line along with the drain line will be attached to the drain installation. With a friend, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electrical unit.
6. Securing the outside of the garbage disposal. This will require securing the old fast-food outlet. The garbage disposal is connected to the backside of the device with two screws. The fast-food outlet will get on the right side.
7. Changing the flange and cover plate. The plenum flange will have 4 screws, and the cover plate will have two screws.
8. Protecting the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by unscrewing the nuts. The base will lift free.
Plumbing Service – Repair and replacement – Garbage Disposal Installation in Pacoima
Every little thing You Need to Understand About Waste Disposals in Pacoima