There are a few things to think about throughout Garbage Disposal Installation in Tarzana. Before you begin, you may want to think about:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be considered a needed part of Garbage Disposal Installation in Tarzana. However, if you already have a sump pump, you might want to consider installing a second back-up sump pump. If you plan to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water may be from the home’s utilities. Suppose your utility is the first source of water. In that case, you will want to set up a U-shaped copper or cast iron pipe almost 18″. To fulfill city regulations in most areas, the pipe ought to be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Ensure that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Proper Disposal- Check with your local codes to know what size drainpipe line and fill your appliance will require. If your disposal is a mix of disposal and trash furnace, you will want to install 2 discharge lines. The cold one should be hooked up to the outside discharge, and the hotline ought to be installed on the plenum flange.
4. Steps- The cold line will be connected to the rough-in drainpipe. The hotline will be connected to the top of the disposal, and the cold outlet line along with the drain line will be connected to the drain installation. With a friend, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electric device.
6. Securing the outside of the garbage disposal. This will require protecting the old fast-food outlet. The garbage disposal is attached to the backside of the unit with two screws. The fast-food outlet will get on the right side.
7. Replacing the flange and cover plate. The plenum flange will have 4 screws, and the cover plate will have 2 screws.
8. Protecting the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by unscrewing the nuts. The base will lift free.
How to Install a Garbage Disposal in Tarzana
New Garbage Disposal Installation Guide in Tarzana