What to Think About During Garbage Disposal Installation in Rancho Cucamonga

There are a few things to think about throughout Garbage Disposal Installation in Rancho Cucamonga. Before you begin, you might want to consider:

1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be considered a necessary part of garbage disposal installation. Nevertheless, if you already have a sump pump, you may want to consider installing a second back-up sump pump. If you intend to have a battery-backup sump pump, you will be prepared in case of a power outage.

2. Connection of Water Line- Your primary source of water may be from the home’s utilities. Suppose your utility is the first source of water. In that situation, you will want to set up a U-shaped copper or cast iron pipe almost 18″. To fulfill city regulations in many areas, the pipe must be a minimum of 18″ maximum in depth when complete. The line will carry the disposer and water to the ground slope. Make sure that you have an appropriate slope on your location and do not have any issues with water running over the top of the drain fitting.

3. Suitable Disposal- Check with your local codes to know what dimension drainpipe line and fill your appliance will require. If your disposal is a mix of disposal and trash furnace, you will want to install 2 discharge lines. The cold one should be connected to the external discharge, and the hotline should be installed on the plenum flange.

4. Levels- The cold line will be attached to the rough-in drain. The hotline will be attached to the top of the disposal, and the cold outlet line along with the drainpipe line will be attached to the drainpipe installation. With a buddy, you will then tape the drain lines to the plenum flange using duct tape.

5. Connecting the garbage disposal and the disposal water line to the house’s electric system.

6. Securing the outside of the garbage disposal. This will require protecting the old fast-food outlet. The garbage disposal is connected to the backside of the unit with 2 screws. The fast-food outlet will get on the right side.

7. Replacing the flange and cover plate. The plenum flange will have 4 screws, and the cover plate will have 2 screws.

8. Protecting the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by loosening the nuts. The base will lift free.

Garbage Disposal installation for new homes in Rancho Cucamonga
Ways to Install a Garbage Disposal in Rancho Cucamonga