There are a few things to think about during Garbage Disposal Installation in Walnut. Before you begin, you may want to think about:
1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be taken into consideration an essential part of garbage disposal installation. Nevertheless, if you already have a sump pump, you may want to think about installing a 2nd back-up sump pump. If you intend to have a battery-backup sump pump, you will be prepared in case of a power outage.
2. Connection of Water Line- Your primary source of water might be from the house’s utilities. Suppose your utility is the first source of water. In that case, you will want to install a U-shaped copper or cast iron pipe almost 18″. To satisfy city regulations in most areas, the pipe needs to be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Ensure that you have an adequate slope on your location and do not have any issues with water running over the top of the drain fitting.
3. Proper Disposal- Check with your local codes to know what dimension drainpipe line and fill your appliance will require. If your disposal is a combination of disposal and trash furnace, you will want to install 2 discharge lines. The cold one should be connected to the outside discharge, and the hotline ought to be installed on the plenum flange.
4. Levels- The cold line will be attached to the rough-in drain. The hotline will be connected to the top of the disposal, and the cold outlet line along with the drainpipe line will be connected to the drainpipe fitting. With a buddy, you will then tape the drain lines to the plenum flange using air duct tape.
5. Connecting the garbage disposal and the disposal water line to the house’s electric unit.
6. Securing the outside of the garbage disposal. This will require securing the old fast-food outlet. The garbage disposal is attached to the backside of the unit with two screws. The fast-food outlet will be on the right side.
7. Changing the flange and cover plate. The plenum flange will have 4 screws, and the cover plate will have two screws.
8. Securing the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by loosening the nuts. The base will lift free.
What to Look For When Choosing a Garbage Disposal Installation Business in Walnut
How to Choose a Garbage Disposal in Walnut