What to Think About During Garbage Disposal Installation in Yorba Linda

There are a few things to consider throughout Garbage Disposal Installation in Yorba Linda. Before you start, you may want to consider:

1. Battery or Back-up Sump Pump- do you need one? Sump Pumps should be considered an essential part of garbage disposal installation. Nevertheless, if you already have a sump pump, you may want to think about installing a 2nd back-up sump pump. If you intend to have a battery-backup sump pump, you will be prepared in case of a power outage.

2. Connection of Water Line- Your primary source of water may be from the house’s utilities. Suppose your utility is the first source of water. In that situation, you will want to set up a U-shaped copper or cast iron pipe just about 18″. To satisfy city regulations in most areas, the pipe should be a minimum of 18″ maximum in depth when full. The line will carry the disposer and water to the ground slope. Guarantee that you have an appropriate slope on your location and do not have any issues with water running over the top of the drain fitting.

3. Proper Disposal- Check with your local codes to know what dimension drain line and fill your device will require. If your disposal is a combination of disposal and trash furnace, you will want to install 2 discharge lines. The cold one need to be hooked up to the external discharge, and the hotline must be installed on the plenum flange.

4. Levels- The cold line will be attached to the rough-in drainpipe. The hotline is going to be connected to the top of the disposal, and the cold outlet line along with the drain line will be connected to the drainpipe fitting. With a friend, you will then tape the drain lines to the plenum flange using duct tape.

5. Connecting the garbage disposal and the disposal water line to the house’s electrical system.

6. Securing the outside of the garbage disposal. This will require protecting the old fast-food outlet. The garbage disposal is connected to the backside of the device with two screws. The fast-food outlet will be on the right side.

7. Changing the flange and cover plate. The plenum flange will have four screws, and the cover plate will have two screws.

8. Protecting the outside of the disposal. Have your helper turn the water back on by turning the knob. Next, you will take off the container by unscrewing the nuts. The base will lift free.

How to Install a Garbage Disposal in Yorba Linda
Garbage Disposal installation for new homes in Yorba Linda